QUELAB

A place to make things!

User Tools

Site Tools


3dprinter_usage

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Last revision Both sides next revision
3dprinter_usage [2016/05/31 23:59]
Morgan Gangwere printer status wordsmithing.
3dprinter_usage [2017/02/23 20:29]
John Benedetto ↷ Links adapted because of a move operation
Line 52: Line 52:
  
     - Turn on the printer. For each printer, there is a switch which controls mains power.     - Turn on the printer. For each printer, there is a switch which controls mains power.
-    - Check the preflight list for [[:hardware:​3dprinter:​start#​makes_and_models|the printer you wish to use]].+    - Check the preflight list for [[:3dprinters#​makes_and_models|the printer you wish to use]].
     - Open MatterControl and connect to the printer you wish to use.     - Open MatterControl and connect to the printer you wish to use.
     - Add the model you wish to print to the MatterControl queue     - Add the model you wish to print to the MatterControl queue
3dprinter_usage.txt · Last modified: 2017/02/23 20:32 by John Benedetto