Welcome Guest 

Show/Hide Header

Welcome Guest, posting in this forum requires registration.
Pages: [1]
Author Topic: RepRap
indrora
n00b
Posts: 11
Permalink
Post RepRap
on: December 7, 2011, 11:31
Quote

What's the status on our 3d printers and friends?

From what I know, the RepRap has problems with the extruder board.

I happen to have a few (dozen) power bricks, but I also happen to have an AVR Dragon available to me if we *really* need something more powerful than an ICSP.

What do we need?
adric
Administrator
Posts: 178
Permalink
Post Re: RepRap
on: December 7, 2011, 12:33
Quote

The makerbot is the one with the extrusion head issues, the reprap as i understand it, is still needing some circuitry troubleshooting/firmware.

-Quelab, Come make something!

indrora
n00b
Posts: 11
Permalink
Post Re: RepRap
on: December 7, 2011, 13:01
Quote

Okay.

The last time I played with it, we had a problem gettign power to the extruder board.

I have a suggestion for the makerbot though: WD-40 and a rubber band :)

Geoff
Administrator
Posts: 21
Permalink
Post Re: RepRap
on: January 5, 2012, 17:51
Quote

The Makerbot's New Extruder Assembly is in the post, and shall be installed forthwith.

This means that the the extruder controller is open to be moved accross the lab to the RepRap (as they use the same hardware) as the only problem with the Makerbot Extruder Assembly is filament feed.
Pages: [1]
Mingle Forum by cartpauj
Version: 1.0.34 ; Page loaded in: 0.021 seconds.

 

Comments are closed.