This shows you the differences between two versions of the page.

Link to this comparison view

blinky [2017/12/20 20:54]
Morgan Gangwere created
blinky [2017/12/21 22:40] (current)
Morgan Gangwere
Line 6: Line 6:
   * E3D v6Lite hotend (someday clone e3dv6)   * E3D v6Lite hotend (someday clone e3dv6)
 +It is configured for OctoPrint running on a Raspberry Pi. Details later.
 +===== Basic maintenance and preflight =====
 +The fan on the extruder should kick on at 50C. If it does not, touch the fan and give it a gentle spin widdershins (anticlockwise).