QUELAB

A place to make things!

User Tools

Site Tools


lasercutter

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
lasercutter [2018/10/14 14:49]
John Benedetto old revision restored (2018/10/14 14:48)
lasercutter [2018/10/14 14:51] (current)
John Benedetto added answer to engraving problem
Line 53: Line 53:
   * Being that the meter show 0mA, that knocks out issues with the optics and leaves the lid switch and the water flow sensor, and possibly the HV power supply, and far less likely the tube. I say less likely and the laser should just get weaker and weaker if it was going out.. Also the meter will only register during actual cutting. It will not move if you only pulse the laser with the button on the control panel.   * Being that the meter show 0mA, that knocks out issues with the optics and leaves the lid switch and the water flow sensor, and possibly the HV power supply, and far less likely the tube. I say less likely and the laser should just get weaker and weaker if it was going out.. Also the meter will only register during actual cutting. It will not move if you only pulse the laser with the button on the control panel.
   * HELP! I see circles instead of a solid engraving!   * HELP! I see circles instead of a solid engraving!
-      * Someone set the advanced engraving option "Fill Circle"​. ​ Uncheck the box to turn it off.+      * Someone set the advanced engraving option "Fill Circle"​. ​ Uncheck the box to turn it off.{{::​lasercut_fill-circle_option.png|}}
  
  
lasercutter.txt ยท Last modified: 2018/10/14 14:51 by John Benedetto